Ball sizes at actual size
A table tennis ball, a golf ball, a tennis ball and a baseball side by side at their real size, each drawn from the sport's own rules. Where a rule allows a range, the dashed outline is the largest ball allowed.
Ball size chart
| Ball | Across | Inches | Rule |
|---|---|---|---|
| Table tennis ball | 40.00 mm across | 1.575 in | ITTF Statutes 2026, 2.3.1: "The ball shall be spherical, with a diameter of 40mm." ITTF Statutes 2026 |
| Golf ball | at least 42.67 mm across | at least 1.680 in | R&A Rules of Equipment 4.3: the diameter must not be less than 1.680 inches (42.67 mm); there is no upper limit. The R&A, Rules of Equipment, part 4 |
| Tennis ball | 65.4 mm to 68.6 mm across | 2.57 to 2.70 in | ITF Rules of Tennis, Appendix I, Table 1: 6.54 to 6.86 cm for type 1 (fast), type 2 (medium) and high-altitude balls; 7.00 to 7.30 cm for type 3 (slow). ITF Rules of Tennis, as printed in the USTA's Friend at Court 2026 |
| Baseball | 72.8 mm to 74.8 mm across | 2.86 to 2.94 in | MLB Official Baseball Rules 2026, 3.01: not less than nine nor more than 9¼ inches in circumference. Official Baseball Rules 2026 |
Not calibrated yet Sizes are estimates until you calibrate with a bank card or a coin.
Sizes are estimates until you calibrate.
Something on the page is covering part of the drawings. Scroll until they are clear before you compare.
Table tennis ball and golf ball compared
People often compare the two, and the golf ball is the bigger one. A table tennis ball is 40 mm across, and a golf ball must be at least 42.67 mm, so the golf ball is at least 2.67 mm wider. Golf's rule sets only a minimum, so a golf ball may be larger but never smaller. Laid on the screen, a table tennis ball should sit on its circle with no outline showing round it.
Advertisement
Tennis balls come in three types
The Rules of Tennis size the ball by its type. Fast (type 1) and medium (type 2) balls, and balls made for play at high altitude, are 6.54 to 6.86 cm across; the slow type 3 ball is larger, 7.00 to 7.30 cm. The drawing shows the fast and medium range. The rules state the sizes in centimetres and say the metric figures take precedence over the inch ones.
Baseballs are set by circumference
Baseball's rule gives the distance round the ball, 9 to 9¼ inches, rather than its width. Divided by π, that is 72.8 to 74.8 mm across, about 2.86 to 2.94 inches, which is why the drawing shows a solid and a dashed outline 2 mm apart. A ball anywhere between them meets the rule.
Advertisement
Checking a ball on screen
Make sure the line above the drawings names your device or says calibrated; if not, calibrate with a bank card or a coin first. Then hold the ball against the screen over its circle and look straight down at it. A ball touching the screen at one point is hard to judge from an angle, so close one eye and line up both edges. To measure a ball whose size you don't know, use the on-screen ruler across its widest part.
More measuring tools
Advertisement
Advertisement
Advertisement