Bubble level
Lay your phone flat on a surface, or stand it on its edge against a shelf or a frame, and centre the bubble. The tilt is shown in degrees.
The level reads your phone's tilt sensor. On iPhone and iPad, Safari will ask for permission to use motion and orientation: tap Allow.
How to use the bubble level
- On a surface. Lay the phone flat, screen up, on the table or shelf you're checking. The bubble drifts towards the high side; when it sits in the centre circle and turns green, the surface is level. The readout gives the total tilt and how much of it is side to side and how much top to bottom.
- On an edge. Stand the phone on its long or short edge, against a shelf or along the top of a picture frame. The level switches to a straight vial and shows how many degrees the edge is from level.
Advertisement
On iPhone and iPad
Safari asks before any page can read the motion sensors, so the level waits for you to tap Start the level and then Allow. If you declined by mistake, close the tab, open this page again in a new tab and tap Allow when Safari asks. On Android phones the level starts straight away.
Setting zero and checking the phone
A case or a camera bump can tip a phone slightly when it lies flat, which shows up as a small tilt on a level surface. To check, take a reading, turn the phone round end to end in the same spot and read again. If the two readings match, the surface is off by that amount. If they differ, the phone itself leans by half the difference: place it on a surface you know is level and tap Set zero here, and later readings are measured from that point.
The level shows a tenth of a degree, and one degree is roughly 1.7 cm of rise over a metre. Phone sensors vary, so for work that has to be exact, confirm with a spirit level.
Degrees, percent and rise per length
Slopes are given in several ways. Builders in the US often say inches per foot, drawings use a ratio such as 1:12, roads a percentage, and this level reads degrees. The table converts between them: percent is the rise divided by the run, times 100, and degrees come from the arctangent of the same ratio. The 2010 ADA Standards set the slopes in the first rows for accessible routes and ramps, so a ramp should read no more than 4.8° on the level.
| Slope | Degrees | Percent | Inches per foot | mm per metre | Note |
|---|---|---|---|---|---|
| 1:100 | 0.57° | 1.0% | 0.12 in | 10 mm | 1 cm over a metre |
| 1:48 | 1.19° | 2.1% | 0.25 in | 21 mm | ADA limit for the cross slope of a walking surface |
| 1/4 in per foot | 1.19° | 2.1% | 0.25 in | 21 mm | a quarter inch over a foot |
| 1:20 | 2.86° | 5.0% | 0.60 in | 50 mm | ADA limit for the running slope of a walking surface |
| 1:12 | 4.76° | 8.3% | 1.00 in | 83 mm | ADA limit for the running slope of a ramp |
| 1:10 | 5.71° | 10.0% | 1.20 in | 100 mm | 10% grade |
| 1:4 | 14.04° | 25.0% | 3.00 in | 250 mm | 25% grade |
| 1:1 | 45.00° | 100.0% | 12.00 in | 1000 mm | 45°, a 100% grade |
More measuring tools
Advertisement
Advertisement
Advertisement