Actual-size credit card
A bank card drawn at its real size: 85.60 mm wide and 53.98 mm tall, the ID-1 format in ISO/IEC 7810. On a recognised or calibrated screen a real card covers the drawing exactly.
Not calibrated yet Sizes are estimates until you calibrate with a bank card or a coin.
Hold your card flat against the screen with its corner in the drawing's top-left corner.
Something on the page is covering part of the card drawing. Scroll until all four edges are clear before you compare.
What the drawing is for
- Sizing a wallet, a card holder or a phone case slot. If the opening is smaller than the drawing, a bank card won't go in.
- Checking your calibration. Lay any bank card over the drawing. If its edges sit on the outline all the way round, every tool on this site is showing true size. If the card overhangs or falls short, calibrate again.
- Seeing how big a card really is when you design one, order a card printer or describe the size to someone else.
Advertisement
The ID-1 card size
Bank cards are made to the ID-1 format of ISO/IEC 7810, the international standard for the physical size of identification cards: 85.60 by 53.98 millimetres, or 3.370 by 2.125 inches. Credit and debit cards use it, and so do many driving licences, national identity cards, transit cards and loyalty cards, which is why one wallet slot fits them all. The corners are rounded, which the drawing shows too.
Turning the card
On a phone held upright, a card laid sideways is wider than the screen, so the drawing starts in portrait there. Use Landscape or Portrait to turn it whichever way suits what you are measuring. Business cards are a different size from bank cards and vary by country, so don't use this drawing for them.
Until the screen is recognised or calibrated, the drawing is only an estimate and the size line above says so. Calibration takes a minute with the same card you are about to compare.
How exact the check is
A card is the best everyday reference for a screen because its width is fixed to a hundredth of a millimetre by the standard and it is long enough to show small errors. If a real card overhangs the outline by 1 mm across its 85.60 mm width, the screen's scale is out by 1.2%, so a 10 cm length would read about 1.2 mm wrong; if the edges line up to within half a millimetre, lengths are right to about 0.6%. The table gives the card in the units people most often ask for.
| Measure | Width | Height |
|---|---|---|
| Millimetres | 85.60 mm | 53.98 mm |
| Centimetres | 8.560 cm | 5.398 cm |
| Inches | 3.370 in | 2.125 in |
| Inches, nearest sixteenth | 3 3/8 in | 2 1/8 in |
| Points (1/72 inch) | 242.6 pt | 153.0 pt |
| Pixels at 300 dpi, for printing | 1011 px | 638 px |
Width to height is 1.586 to 1, and the card's face is 46.2 cm².
More measuring tools
Advertisement